A Spa Day For Your Skydiving Rig
Charlie Chaplin has nothing on you. That landing was nothing less than *art*.
You managed to use that doofus downwind setup to milk every last opportunity for comedy out of your return to earth. You nailed the exaggerated “uh-oh” expression. You executed the perfect shortbus flare. You transitioned majestically from a banana-peel touchdown to a ten-foot skid through the one spot of mud in the landing area.
You, my friend, are awesome.
Now, you’re going to have a nice laundry day. Here’s how.
Wait for it.
If you’ve managed to drag your beautiful gear through the mud, you’re going to have to stare at it in shame for a while before you make a move. Wait for it to dry completely -- which may take a couple of days -- then scrub off what you can with a dry brush.
Take it apart.
Remove both canopies from the rig. (Do this after performing a practice reserve deployment -- as you always do before a repack, right?) Remove your AAD from the rig. Remove all hardware: reserve handles, risers, RSL, hook knife, etc. If you’re not comfortable doing this yourself, ask for help from a rigger.
Treat your rig like a dog.
...or, at least, like you’re administering a doggie bathtime. Gather a big plastic tub, gentle detergent (such as Woolite or castile soap) and a nylon scrub brush. Fill the tub about halfway with lukewarm -- not hot -- water. Dunk your empty rig and agitate it in the soapy water, but don’t let it sit and soak. After the container is fully saturated, go at it with your scrubber. Repeat the dunk-and-shake cycle. Once your rig is good and scrubbed, empty the tub and refill it with soapless, lukewarm water. Dunk and dunk and dunk, emptying and refilling the tub as necessary, until not even the tiniest hint of soap remains. (Dried-on soap is a filth magnet.)
...Or treat your rig like fine lingerie.
You can machine-wash a rig, but you’d better make sure you act like it’s a set of ridiculously fancy, spendy underthings. (Ridiculously fancy, spendy underthings with hip rings, of course, that need to be strapped up with athletic tape to keep them from denting the inside of your machine…) Put your empty, hardwareless, Velcro-mated rig in a mesh laundry bag and run it with gentle detergent on the delicate cycle.
String it up.
Hang your wet skydiving container in a dry place that isn’t exposed to direct sunlight. As you get it set up, straighten every flap and fold to prevent wrinkles from locking in. Keep tabs untucked. If your rig has Cadmium hardware, you’ll need to do a thorough hand-drying pass with a towel at the very beginning to prevent rust.
Stop time.
Okay. You can’t stop time. You can, however, encourage the time between cleanings to maybe slow down a little bit.
After your rig is spotlessly, white-glove-test-ready, make-your-mama-proud clean -- and as dry as the beer truck at the end of the Skydive Arizona Christmas Boogie -- you can apply a single coating of fabric protection, such as Scotchgard, to shield it against redirtying. Check the manufacturer’s recommendation for application before you get all spray-happy. That said, the general advice is to apply three whisper-light coats of protectant, making sure each coat is dry before applying a new one. Make sure you do this in a well-ventilated area (lest you waterproof your lungs).
Get out, damned spot.
Keep a baggie of stain-removing wipes in your skydiving gear kit. They’re a lifesaver for little oopsies.
Take a canopy course.
...or start working at a laundromat to save money. Your call, Charlie.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.