Recommended Posts
QuoteAgain, my ignorance reigns supreme, but does it make sense that if you configure your rig for the lowest possible jump, you could use that same configuration for all other (higher) jumps? Correct me if I'm wrong...
This is wrong. I think it's beyond the scope of this thread to elaborate, but basically, the parachute must be configured to open at a rate compatible with your freefall speed. Failure to do so will result in an extremely hard opening, damage to the equipment, damage to the jumper, or all three.
QuoteYou even mention how any minor rigging error can kill you... as far as I know, the reason for these rigging procedures is DUE to the low altitude.
The application for some of these procedures is for low altitude jumps, yes. But this has nothing to do with why the errors occur. I'm not sure what you're getting at.
QuoteI'd be curious to find a BASE fatality statistics page, but somehow I doubt there is one.
Not a statistics page, but enough to get you started. The List
QuoteI've only heard of a few BASE fatalities that I've read about in mainstream publications, but all of them seemed to be in open areas, death from impact against a horizontal ground, and nothing else. I can only assume that if the ground had been 2500 ft lower and the jumper had a reserve, he would not have gone in.
Read the above list and tell me if you still think that. Then re-read my first reply, particularly the part referring to intentionally using available altitude.
My advice to you is to read all you can about BASE jumping. After you have more knowledge of the sport, you'll be able to ask more accurate questions.
Share this post
Link to post
Share on other sites