theskydiveguy 0 #1 January 27, 2004 Hey Guys, I am posting this for a friend, he has a Z1 that he want's to take the visor off of and cant seem to figure out how! Any advice? Thanks ~Jeff Monkey Brother #1 http://www.monkeybrothers.ca Quote Share this post Link to post Share on other sites
SkydiveMonkey 0 #2 January 27, 2004 Take the liner out, there's 2 kinda screws on the inside. With a screwdiver (or equiv) on the OUTSIDE (to stop it spinning), turn the inside ones 90 degrees and you should be able to take the bolts out. Make a note of how the came out you can put em back later . Do the same on the other side. (I'm doing this from memory so take it with a pinch of salt ..)____________________ Say no to subliminal messages Quote Share this post Link to post Share on other sites
theskydiveguy 0 #3 January 27, 2004 Thanks Monkey :) I will let him know! ~Jeff Monkey Brother #1 http://www.monkeybrothers.ca Quote Share this post Link to post Share on other sites
Dumpster 0 #4 January 27, 2004 Just like the Monkey said - I think a 12 or 13mm wrench helps hold those little nuts on the inside. There's a spring in there, too, so beware. Just a quarter turn, don't force it, and it'll all be good. I put a new face-plate on mine once a year, takes about ten minutes start to finish. Z-1s Rock. Easy Does It Quote Share this post Link to post Share on other sites
theskydiveguy 0 #5 January 27, 2004 Thanks guys! I have forwarded all the info to my non-computer using buddy. Told him this was the place but he couldnt figure out how to use it! Thanks again, ~Jeff Monkey Brother #1 http://www.monkeybrothers.ca Quote Share this post Link to post Share on other sites
Dumpster 0 #6 January 27, 2004 No sweat - Cool rig in the avatar, too, man! Easy Does It Quote Share this post Link to post Share on other sites
