phoenixlpr 0 #1 March 10, 2004 Hiall! Is there user manual on the net? Is this device has a mandatory service/inspection period? Where can I find info about it? Quote Share this post Link to post Share on other sites
bjornufknu 0 #2 March 10, 2004 http://www.pia.com/fxc/2B1M12000.htm Did not find much... But I have a great link with lots of info about the FXC in Swedish if you would like! =)d.d.s. Quote Share this post Link to post Share on other sites
councilman24 37 #3 March 10, 2004 Yes it has a factory calibration cycle. It's been a while since I delt with one but I THINK it was two years. With the change in part 105 this is now legally madated. If your trying to fit this to an experience jumper rig, you probably want to reconsider. It probably won't fit, the rig will have to be modified if not already set up for it, most newer rigs probably may not offer an FXC set up, it weighs a bunch, and is relatively inprecise on activation and leads to two out quite often for skydivers pushing lower. We routinely set our student FXC's at LEAST a 1000 feet below the hard deck canopy open altitude. http://websearch.cs.com/cs/search?query=guardian+fxc+12000&x=0&y=0&fromPage=CSBoom That said the USAF academy has 200-300 student rigs set up with dual FXC 12000's, one for the main and one for the reserve. They are they're own service station.I'm old for my age. Terry Urban D-8631 FAA DPRE Quote Share this post Link to post Share on other sites
markbaur 0 #4 March 10, 2004 Quote We routinely set our student FXC's at LEAST a 1000 feet below the hard deck canopy open altitude. The warning sticker on the control unit reads, "Caution. Main canopy opening must be 1500 feet minimum above the unit preset release altitude." [My emphasis.] Mark Quote Share this post Link to post Share on other sites
phoenixlpr 0 #5 March 10, 2004 Thanks for all the answers. Quote Share this post Link to post Share on other sites
masterrig 1 #6 March 10, 2004 You might contact FXC-Guardian, Corp. The FXC-12000, must be chamber tested every inspection and re-pack of the reserve or after use. Every 2-yrs., the unit must be returned to the manufacturer for calibration and inspection. Hope, this helps. Chuck Quote Share this post Link to post Share on other sites
councilman24 37 #7 March 10, 2004 Yeah, I couldn't remember whether it was 1000 or 1500.I'm old for my age. Terry Urban D-8631 FAA DPRE Quote Share this post Link to post Share on other sites
phoenixlpr 0 #8 March 11, 2004 Ive received some documents from FXC. Well, they were quite fast. http://spidernest.ath.cx/~phoenix/Model_12000_Manual.pdf http://spidernest.ath.cx/~phoenix/Model_12000_Service_Bulletin.pdf Quote Share this post Link to post Share on other sites
1234hutch 0 #9 March 14, 2004 Hi read very carfully on the face plate of the fxc . It recommends 1500ft separation. As does the manual Hutch Quote Share this post Link to post Share on other sites
