wilcox 0 #1 November 10, 2005 Does anyone know why the pin connected to the right riser should be on top on an atom with lor-2 pin system? And why can you disconnect the right riser pin? Since the right pin is on top, wouldn't you want the left pin to be the one to be disconnected? I'm sure there is a good reason for the current construction, I'm just curious what the reasons are. Quote Share this post Link to post Share on other sites
BlueSBDeath 2 #3 January 7, 2007 Have you asked the people that build the system? I would think that the manufacter would have the answer.BSBD...........Its all about Respect, USPA#-7062, FB-2197, Outlaw 499 Quote Share this post Link to post Share on other sites
parafredo 0 #4 January 7, 2007 If you want,I can e-mail you the manual if you need it. Quote Share this post Link to post Share on other sites
wilcox 0 #5 January 7, 2007 I've got some manuals for Atoms. Is there an answer to this question there? Which page? Which year is the manual from? Quote Share this post Link to post Share on other sites
ericfradet 0 #6 January 7, 2007 The reason has nothing to see with the pins release order .. I was wondering the same question about 2 months ago I have been asking the manufacturer about the reason why ? the only reason is to avoid the pin to rotate inside the cover pin , PdF found out that on smallest containers by putting the right pin above the left one, both pins stays flat better.. Quote Share this post Link to post Share on other sites
