phoenixlpr 0 #1 September 21, 2009 I'm working on my gps data logger of my own. In the perspective of the gps logger how would you define exit, deployment? Quote Share this post Link to post Share on other sites
lost_n_confuzd 0 #2 September 21, 2009 QuoteI'm working on my gps data logger of my own. In the perspective of the gps logger how would you define exit, deployment? If I understand you correctly...to put it in GPS terms? Exit - Jump elevation Deployment - Pull elevation Maybe, no? Quote Share this post Link to post Share on other sites
phoenixlpr 0 #3 September 21, 2009 You got a set of data. Each entry has time, position, elevation, ground speed. How can you find possible exit/deployment from the data? Quote Share this post Link to post Share on other sites
JackC 0 #4 September 21, 2009 Just look for points where the vertical speed changes abruptly. For exit, you want the point where the vertical speed changes from close to zero to 100mph+ with a fairly well defined acceleration curve. For deployment look for when the vertical speed slows dramatically, 100mph+ to almost zero in a few seconds. Or you could look for the points where the altitude starts and stops decreasing rapidly. Quote Share this post Link to post Share on other sites
JohanW 0 #5 September 28, 2009 For wingsuit flights, you may very well want the impossible. Obviously, you look at the biggest accelerations, positive for exit and negative for deployment (or the other way around - depends). But exit a Skyvan, pop up, fly, flare the suit halfway down, fly, deploy, spiral the canopy down, and you just can't see from the data what happened when. I know I can get higher instantaneous speeds under canopy than I can get in my wingsuit. That's a Triathlon 120 vs a Skyflyer 3S. Lots of people fly bigger suits and smaller canopies (some even at the same time ). Can't be done, not perfectly. A quick and dirty approximation should not be too difficult however, and refine from there. How complicated do you want your algorithm to become? Johan. I am. I think. Quote Share this post Link to post Share on other sites