rendezvous 0 #1 September 4, 2002 where does one get that little washer that sits between the closing loop knot and the grommet on the flap. Quote Share this post Link to post Share on other sites
PhreeZone 20 #2 September 4, 2002 Local Hardware store... a box of 100 for about $2.50Yesterday is history And tomorrow is a mystery Parachutemanuals.com Quote Share this post Link to post Share on other sites
rendezvous 0 #3 September 4, 2002 is there a size, number or anyother specification to which one they are. Quote Share this post Link to post Share on other sites
PhreeZone 20 #4 September 4, 2002 I've always just looked to see what was close and on sale... *shrug*Yesterday is history And tomorrow is a mystery Parachutemanuals.com Quote Share this post Link to post Share on other sites
riggermick 7 #5 September 5, 2002 Quotewhere does one get that little washer that sits between the closing loop knot and the grommet on the flap. Try using SAE #6 steel flat washers, from your local hardware store. Check for sharp edges inside before using. Mick. Quote Share this post Link to post Share on other sites
councilman24 37 #6 September 5, 2002 What may work better and I've used is the "backers" for POP rivets. They're thicker and don't bend.I'm old for my age. Terry Urban D-8631 FAA DPRE Quote Share this post Link to post Share on other sites
rapper4mpi 0 #7 September 6, 2002 Again, please watch for sharp edges on the inside ring, these can slowly cut into and fray the closing loop in a not so inspectable place. -Rap Quote Share this post Link to post Share on other sites
barry 0 #8 September 6, 2002 QuoteAgain, please watch for sharp edges on the inside ring, these can slowly cut into and fray the closing loop in a not so inspectable place. -Rap Quote Share this post Link to post Share on other sites
