sbhesq 0 #1 May 30, 2010 I know it has been asked before ... but I can't find the answer...My pc1000 is giving me a reinsert cassette error fairly often now and I would like to send it in to be repaired. Does anybody have any suggestions as to where is the best place to send it? Thanks, Steve Quote Share this post Link to post Share on other sites
Skydave103 0 #2 May 31, 2010 the $$ you would spend to fix it ($250 min i think is what Sony charges + parts) you can buy a new digital camera and not have to buy tapes, no moving parts, HD etc etc etcLifeshouldNOTbeajourneytothegravewithawellpreservedbody,buttskidinsideways,cigarinone hand,martiniintheother,bodythoroughlyused upandscreaming:"WOO HOO!! What a ride!!!" Quote Share this post Link to post Share on other sites
sbhesq 0 #3 May 31, 2010 I hear ya, but they are still selling for $500 on ebay so it is likely worth it. I am shooting a cx100 now as well, but I still like the pc1000. Quote Share this post Link to post Share on other sites
AndyMan 7 #4 May 31, 2010 I have the same problem with mine, but it's sitting on my shelf collecting dust because I haven't bothered to fix it. I was quoted $400 to fix it, and a new camera is way cheaper. _Am__ You put the fun in "funnel" - craichead. Quote Share this post Link to post Share on other sites
freefalle 0 #5 May 31, 2010 There's a place in Holly Hill Florida called Green's Camera Tech 386.257.1366 I always took my old PC camera to them when I had problems. There prices are always reasonable. I hope that helps. Chuck Bryan Quote Share this post Link to post Share on other sites
kai3fly 0 #6 May 31, 2010 http://www.precisioncamera.com/ has a flat rate of $250, most places are $400, shitty state of affairs cost of repair is higher than new stuff. be green man i have 2 broken ones and one working, will be selling them all at the end of the summer with Rawa Helmet any takers? Quote Share this post Link to post Share on other sites
skyfriend 0 #7 June 2, 2010 I google'd the error code for my PC-9 cassette error. Found a lot of message board topics. One was very helpful - a spindle had fallen out (from a hard knock perhaps and over 100 hours of use). Repair was electrical shrink-tubing on a tiny locking tube. Have used the camera for probably 100 jumps since. Clear instructions were on the web. Maybe your error is same... Quote Share this post Link to post Share on other sites