stratostar 5 #1 November 30, 2012 I did a quick search and I have DSE's book, but I can't find the answer.... Problem: When adding a trans between clips, simple crossfade, for some reason it and some how it grabs the first of the next frame and fucks up the clip order. In other words, if the crossfade goes between the shot of the suit up then fades to the TDM pair walking out the door, to the third clip of them walking to the plane..... it grabs part of the walking the plane part and puts it in front the walking out the door part.... just a few seconds of it and it totally fucks up the work flow order???? WTFyou can't pay for kids schoolin' with love of skydiving! ~ Airtwardo Quote Share this post Link to post Share on other sites
DSE 5 #2 November 30, 2012 I'm betting you have Looping enabled, and are dragging the clip/event past its end point. right click, Choose SWITCHES, be sure that LOOP is not checked. Quote Share this post Link to post Share on other sites
stratostar 5 #3 November 30, 2012 Ok.... you rock star!Ok I've been looking and will still try to learn on my own...buy why is the loop locked on for all the clips, I mean I uncheck it to fix the first place I had the problem, then I find all the other following clips it's on too... No problem to check it each time, but I know there is something I've done wrong or not doing right here.. THX you can't pay for kids schoolin' with love of skydiving! ~ Airtwardo Quote Share this post Link to post Share on other sites
DSE 5 #4 December 1, 2012 Looping is on by default. You can disable it, and save it per project. Most people actually prefer it vs a freezeframe. You can also permanently disable it by going to Preferences | Editing tab, and in the top selection, disable looping by default. Quote Share this post Link to post Share on other sites
stratostar 5 #5 December 2, 2012 Thanks, because I have been looking all over and reading a lot, all good stuff... But again, thanks to your fast reply I was able to complete learning project. Oh, come to think of it, I think I recall see it in that tab, when following your books instructions in chap 3 pg 64 to 67.... FYI- I followed the instructions 4 or 5 times and each time I render it fails and says there is a unknown problem. And I have only been able to render to video for windows (*avi) and that is fine for my quest to upload my learning videos to utube. The first thing that came to mind was I'm editing SD footage and not AVCHD? IDK, but that was one for those first majors that came up, but kept playing around and found a work around, been meaning to call... you can't pay for kids schoolin' with love of skydiving! ~ Airtwardo Quote Share this post Link to post Share on other sites
