MalcolmR 0 #1 October 30, 2013 To anyone using a replay XD, what is the lowest profile mount you found? And on what helmet? Quote Share this post Link to post Share on other sites
DSE 5 #2 October 30, 2013 I'm using the lowboy. It's as low profile as it gets. Using on a Tonfly CC1, CC3, and Bonehead FTP Quote Share this post Link to post Share on other sites
Grumpy 9 #3 June 7, 2014 DSE, I just picked up a 1080 mini to top mount on a G3. The curved "snap tray" is more curved than the profile of the helmet so there's clear space under the centre of the mount reducing the mating surface area. Turning it 90 degrees allows it to match the profile of the helmet better but then I have to use the taller hemi-lock so the camera can be pointed forward. Would adding a small circle (half inch diameter) of VHB tape so there's a double layer in the middle of the snap tray be a good idea do you think? Can you think of any other way I could improve the interface between the two surfaces? Thanks. Quote Share this post Link to post Share on other sites
monkycndo 0 #4 June 7, 2014 Can you take a Dremil tool and shave the "outboard" ends of the mount until the center fits tight so you get more mount/helmet contact area?50 donations so far. Give it a try. You know you want to spank it Jump an Infinity Quote Share this post Link to post Share on other sites